High Quality B51-2 Advance Acrylic Latex Sealing Primer With Good Price-yms...

这里可以自定义设置

PRODUCT DESCRIPTION

This product is mainly prepared by acrylic copolymer, pigments and auxiliaries.This lasting product appears rich and beautiful look. Also, it is fast- drying, easy to apply, and low VOC formula.

It features:

● Water based

● Odorless & nontoxic

● Easy to apply

● Excellent permeability

● Over 2000 times scrub resistance

● Excellent resistance to water, mildew and alkali

Typical Uses:

This product is mostly applied on top of epoxy painting in various environments such as offshore facilities, petrochemical plants and bridges. It can be used in pulp mills, paper factories and power plant too. Besides, it is also seen in epoxy system which protects concrete structu

这里可以自定义设置

PRODUCT SELLING POINT

● Mainly used for residential and civilian buildings as decorative and protective material.

● Mainly prepared by acrylic copolymer, pigments and auxiliaries.

● Excellent resistance to water, mildew and alkali.

● Mainly used for residential and civilian buildings as decorative and protective material.

PRODUCT ADVANTAGES

50% Avoid slips and increase safety by50%

Extend the service life by 2-3 years

Five years bright as new,5.99% improve the yield of sensitive devices by99%

Resistance(chemical medium)98% sulfuric acid,30% hydrochloric acid carefree

这里可以自定义设置

PRODUCT PARAMETER

Mixing	Use the power mixer to mix the main paint evenly, and then add the hardener and stir until it is well mixed. Generally speaking, when the temperature is below 10℃, 30min will be waited before you use it; 15min when it is above 10℃.
Mixing ratio	Part A: Part B= 18:9 (by weight)
Thinner	X-7 Epoxy thinner
Airless spray	Nozzle tip: 0.021~0.025 inches Spray pressure: 15~18Mpa Thinner ratio: 0~15% (by weight of paint)
Brush、Roller	Recommended for small areas only. Must achieve required thickness.

MORE SPECIFIC COLORS PLEASE CONSULT US

DRYING SCHEDULE

Substrate Temperature	5℃	23 ℃	40℃
To touch/h	≤1	≤2	-
To handle/h	≤3	≤3	-
To cure	≤7	≤3	-

* The surface must be solid, clean and dry, free from efflorescence, dust, oils and other contaminants. Also, the surface PH must be lower than 10.

* Deteriorated previous coatings, weak, friable & blistered paints or chalky substances should be removed and then smooth it thoroughly.

* If any, rinse moldy walls with hot bleaching agent for 10 minutes, and then flush it with tap water thoroughly. Apply this product within 48 hours after surface dried.

PRODUCT SPECIFICATIONS

Color	Cream white
Density, kg/L	1.01
Volume solid, %	9.1
Adhesion, grade	≤1
Low temperature stability	No deterioration
Water resistance ,h	≤0.3
Salting-out resistance,h	≥144

这里可以自定义设置

PRODUCT APPLICATION

Substrate temperature shall be at 3 ℃ higher than dew point, relative humidity less than 85%. Measurement of temperature and humidity should be close to substrate.